When the AUTO function is set to ON/OFF, a message is displayed on the multi-information display in the combination meter assembly.
The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (brake warning switch assembly)*1 or electric parking brake switch (integration control and panel assembly)*2 as the parking brake indicator light blinks when the ignition switch is first turned to ON.
*1: for Manual Transaxle
*2: except Manual Transaxle
Check that the AUTO function operates when the operating conditions are met.
Do not use the multi-information display to determine whether the AUTO function is operating or not.
| Result | Proceed to |
|---|---|
| The AUTO function operates | A |
| The AUTO function does not operate | B |
A
B