When the downhill assist control switch is turned on, the downhill assist control function is available and the downhill assist control indicator light illuminates.
Refer to Downhill Assist Control Indicator Light does not Come ON.
After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and store system information memorization.
Disconnect the A39 skid control ECU (brake actuator assembly) connector.
Disconnect the G32 downhill assist control switch (integration control and panel assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A39-8 (HDCS) - G32-19 (B) | Always | Below 1 Ω |
| A39-8 (HDCS) or G32-19 (B) - Body ground | Always | 10 kΩ or higher |
| G32-16 (E) - Body ground | Always | Below 1 Ω |
| Result |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Perform the Active Test of the combination meter assembly using the GTS.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display |
|---|
| Downhill Assist Control Indicator |
Check the combination meter assembly.
The downhill assist control light turns on or off in accordance with the GTS operation.
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for LHD with Vacuum Brake Booster)>REMOVAL
for RHD: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR (for RHD with Vacuum Brake Booster)>REMOVAL
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING