The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake actuator assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for M20A-FKS:
for A25A-FKS:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
4.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55704B
5.REMOVE COWL VENTILATOR PANEL SUB-ASSEMBLY
6.REMOVE BRAKE ACTUATOR WITH BRACKET
|
Release the lock lever |
|
Disconnect the connector |
Release the lock lever and disconnect the connector from the brake actuator assembly.
Be careful not to allow any brake fluid to enter the connector.
| *a | From 1st Chamber of Brake Master Cylinder Sub-assembly |
| *b | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly RH |
| *d | To Rear Wheel Cylinder Assembly LH |
| *e | To Rear Wheel Cylinder Assembly RH |
| *f | To Front Wheel Cylinder Assembly LH |
Use tags or make a memo to identify the places to reconnect the brake lines.
Using a union nut wrench, disconnect the 6 brake lines from the brake actuator assembly.
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Disengage the 5 clamps to separate the brake lines from the brake tube clamp.
Do not kink or damage the brake lines.
Remove the bolt and brake tube clamp.
Remove the 2 bolts, nut and brake actuator with bracket.
Do not kink or damage the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Be careful not to allow any brake fluid to enter the connector.
Do not hold the brake actuator assembly by the connector.
Do not drop the brake actuator with bracket when carrying it.
Remove the brake actuator with bracket while avoiding the brake lines.
44510
7.REMOVE BRAKE ACTUATOR ASSEMBLY
Remove the 3 bolts and brake actuator assembly from the brake actuator bracket assembly.
Do not hold the brake actuator assembly by the connector.
Be careful not to allow any brake fluid to enter the connector.
Do not drop the brake actuator assembly when carrying it.
44547B
8.REMOVE BRAKE ACTUATOR BRACKET CUSHION
| *1 | No. 1 Brake Actuator Case Collar |
| *2 | Brake Actuator Bracket Cushion |
Remove the 3 nuts and separate the brake actuator bracket assembly.
Remove the 3 No. 1 brake actuator case collars from the brake actuator bracket cushion.
Remove the 3 brake actuator bracket cushions from the brake actuator bracket assembly.