Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)
RM3620E _54 Brake _076410 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0379312 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/o Vacuum Brake Booster)  C1249  Open Circuit in Stop Light Switch Circuit  


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) receives the stop light switch assembly signal and detects the brake pedal operation status.

The skid control ECU (brake booster with master cylinder assembly) has an open detection circuit, which stores this DTC if it detects an open in the stop light input line or ground line of the stop light circuit with the stop light switch assembly off (brake pedal not depressed).

DTC No. Detection Item INF Code DTC Detection Condition Trouble Area Note
C1249 Open Circuit in Stop Light Switch Circuit 231 When IG1 terminal voltage is 9.5 V higher than, an open circuit occurs between STP terminal circuits A and B for 10 seconds or more.
·

Harness or connector

·

Skid control ECU (Brake booster with master cylinder assembly)


-

WIRING DIAGRAM

C405822E03
1.542,0.542 2.083,0.802 0.542,0.26 10 false A29 1.573,0.781 4.021,1.094 2.448,0.313 10 false Hybrid Vehicle Control ECU Assembly 2.969,0.333 3.51,0.594 0.542,0.26 10 false STP 3.375,0.229 3.917,0.49 0.542,0.26 10 false 7 4.667,0.219 5.208,0.479 0.542,0.26 10 false 25 4.927,0.344 5.469,0.604 0.542,0.26 10 false STP1 4.271,0.521 4.813,0.781 0.542,0.26 10 false M7 4.281,0.781 7.083,1.073 2.802,0.292 10 false Certification ECU (Smart Key ECU Assembly) 1.156,1.188 2.667,1.552 1.51,0.365 10 false from Auxiliary Battery 0.969,2.281 1.51,2.542 0.542,0.26 10 false STOP 1.542,1.948 2.083,2.208 0.542,0.26 10 false 7 3.365,1.646 3.906,1.906 0.542,0.26 10 false 3 3.396,2.594 3.938,2.854 0.542,0.26 10 false 4 5.208,1.635 5.75,1.896 0.542,0.26 10 false 6 5.219,2.552 5.76,2.813 0.542,0.26 10 false 3 1.229,4.031 1.771,4.292 0.542,0.26 10 false A40 1.583,4.031 3.438,4.333 1.854,0.302 10 false Stop Light Switch Assembly 3.875,4.719 4.417,4.979 0.542,0.26 10 false N18 2.302,5.385 4.229,5.896 1.927,0.51 10 false Rear Combination Light Socket and Wire LH 3.875,6.188 4.417,6.448 0.542,0.26 10 false M14 2.292,6.896 4.24,7.469 1.948,0.573 10 false Rear Combination Light Socket and Wire RH 0.177,8.375 2.031,8.667 1.854,0.292 10 false Center Stop Light Assembly 3.896,7.688 4.438,7.948 0.542,0.26 10 false R1 3.104,1.667 3.646,1.927 0.542,0.26 10 false L 2.938,2.552 3.479,2.813 0.542,0.26 10 false ACC 2.927,3.542 3.469,3.802 0.542,0.26 10 false OUT 1.771,3.552 2.313,3.813 0.542,0.26 10 false GND 1.792,1.958 2.333,2.219 0.542,0.26 10 false B 5.458,1.635 6,1.896 0.542,0.26 10 false STP2 5.49,2.573 6.031,2.833 0.542,0.26 10 false STPO 0.552,4.906 1.313,5.125 0.76,0.219 10 false Stop Light 3.625,7.958 4.167,8.219 0.542,0.26 10 false E 5.177,3.552 5.719,3.813 0.542,0.26 10 false 33 3.354,3.552 3.896,3.813 0.542,0.26 10 false 1 1.542,3.563 2.083,3.823 0.542,0.26 10 false 2 3.958,4.927 4.5,5.188 0.542,0.26 10 false 3 3.958,4.531 4.5,4.792 0.542,0.26 10 false 2 3.958,5.99 4.5,6.25 0.542,0.26 10 false 2 3.938,7.896 4.479,8.156 0.542,0.26 10 false 1 3.948,6.396 4.49,6.656 0.542,0.26 10 false 3 3.948,7.479 4.49,7.74 0.542,0.26 10 false 2 3.635,4.646 3.844,5.031 0.208,0.385 10 false B 3.583,6.104 3.844,6.385 0.26,0.281 10 false B 5.479,3.521 6.021,3.781 0.542,0.26 10 false STP 4.865,4.344 5.406,4.604 0.542,0.26 10 false A42 4.885,4.542 6.938,5.094 2.052,0.552 10 false Skid Control ECU (Brake Booster with Master Cylinder Assembly) 3.635,5.01 4.177,5.271 0.542,0.26 10 false E 3.583,6.479 4.125,6.74 0.542,0.26 10 false E 3.615,7.594 4.156,7.854 0.542,0.26 10 false B 4.688,3.823 4.917,4.083 0.229,0.26 10 false A 5.229,3.802 5.458,4.063 0.229,0.26 10 false B 3.875,5.125 4.417,5.385 0.542,0.26 10 false N18 3.865,6.583 4.406,6.844 0.542,0.26 10 false M14 3.906,8.083 4.448,8.344 0.542,0.26 10 false R1 0.229,5.448 1.854,5.844 1.625,0.396 10 false Stop Light LED 0.188,6.896 1.542,7.292 1.354,0.396 10 false Stop Light LED 2.229,8.375 4.542,8.656 2.313,0.281 10 false Center Stop Light Cord Assembly 2.094,4.729 2.323,4.99 0.229,0.26 10 false A 2.094,5.125 2.323,5.385 0.229,0.26 10 false A 2.094,6.188 2.323,6.448 0.229,0.26 10 false B 2.083,6.583 2.313,6.844 0.229,0.26 10 false B 2.094,7.677 2.323,7.938 0.229,0.26 10 false C 2.083,8.083 2.313,8.344 0.229,0.26 10 false C 2.083,4.51 2.625,4.771 0.542,0.26 10 false 1 2.094,4.927 2.635,5.188 0.542,0.26 10 false 2 2.104,5.979 2.646,6.24 0.542,0.26 10 false 1 2.104,6.375 2.646,6.635 0.542,0.26 10 false 2 2.094,7.479 2.635,7.74 0.542,0.26 10 false 2 2.094,7.896 2.635,8.156 0.542,0.26 10 false 1 0.573,6.333 1.333,6.552 0.76,0.219 10 false Stop Light 0.573,7.854 1.333,8.073 0.76,0.219 10 false Stop Light

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>UTILITY


PROCEDURE

1.READ VALUE USING GTS (STOP LIGHT SWITCH ASSEMBLY)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Select the Data List on the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DATA LIST / ACTIVE TEST

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Stop Light SW Stop light switch assembly ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Chassis > ABS/VSC/TRC > Data List
Tester Display
Stop Light SW
50003 105 37

d.

Check that the stop light switch assembly display observed on the GTS changes according to brake pedal operation.

OK:

The GTS displays ON or OFF according to brake pedal operation.



Result:
Proceed to
OK
NG



OK

2.RECONFIRM DTC

NG

3.CHECK HARNESS AND CONNECTOR (STP TERMINAL)
2.RECONFIRM DTC

b.

Turn the power switch off.


c.

Turn the power switch on (READY).


d.

Depress the brake pedal several times to test the stop light circuit.


e.

Check if the same DTC is output.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTC C1249 is not output. A
DTC C1249 is output. B


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>PROBLEM SYMPTOMS TABLE




A

B

3.CHECK HARNESS AND CONNECTOR (STP TERMINAL)
a.
C316493C42
0.208,0.729 0.594,0.99 0.385,0.26 1.552,2.146 0.875,2.823 false 0.177,0.156 0.49,0.354 0.313,0.198 10 false *a 0.281,0.781 0.74,0.979 0.458,0.198 10 false A42 0.719,2.844 1.177,3.042 0.458,0.198 10 false STP
*a Front view of wire harness connector
(to Skid Control ECU (Brake Booster with Master Cylinder Assembly))


Turn the power switch off.


b.

Make sure that there is no looseness at the locking part and the connecting part of the connector.


c.

Disconnect the A42 skid control ECU (brake booster with master cylinder assembly) connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A42-33 (STP) - Body ground Stop light switch assembly on (Brake pedal depressed) 11 to 14 V
A42-33 (STP) - Body ground Stop light switch assembly off (Brake pedal released) Below 1.5 V


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>PROBLEM SYMPTOMS TABLE



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (STP CIRCUIT)