The No. 1 power back door control switch signal is sent to the multiplex network door ECU.
If the power back door does not operate using the No. 1 power back door control switch, a No. 1 power back door control switch circuit malfunction is a possible cause.
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for Gasoline Model)>INITIALIZATION
Read the Data List according to the display on the GTS.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| PBD Close SW | No. 1 power back door control switch signal | ON or OFF | ON: No. 1 power back door control switch pushed
OFF: No. 1 power back door control switch not pushed |
- |
| Tester Display |
|---|
| PBD Close SW |
The No. 1 power back door control switch functions as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the No. 1 power back door control switch.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CLOSER SWITCH>REMOVAL
Inspect the No. 1 power back door control switch.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR CLOSER SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the R17 No. 1 power back door control switch connector.
Disconnect the R18 multiplex network door ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R17-1 (CLS) - R18-8 (BDDN) | Always | Below 1 Ω |
| R17-2 (E) - Body ground | Always | Below 1 Ω |
| R17-1 (CLS) or R18-8 (BDDN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG