Signals are input into the position control ECU assembly (driver seat). The built-in ECU manages the signals received from the power seat switch and operates each motor. If the position control ECU assembly (driver seat) receives more than 2 motor operation signals for the same motor, the motor will be stopped. Manual operation resumes when the position control ECU assembly (driver seat) receives only 1 signal.
Inspect the fuses for circuits related to this system before performing the following procedure.
Initializing the position control ECU assembly (driver seat) will clear the seat position memory.
Make sure to initialize the position control ECU assembly (driver seat) after replacing the seat assembly or any related parts (including removal and installation).
Click hereVehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (for HV Model with Memory)>REGISTRATION
Check that each function of the power seat operates normally by using the front power seat switch (driver seat).
Click hereVehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (for HV Model with Memory)>OPERATION CHECK
| Result | Proceed to |
|---|---|
| All power seat functions do not operate | A |
| One or more power seat functions do not operate | B |
A
B
| *A | for LHD |
| *B | for RHD |
| *a | Front view of wire harness connector
(to Position Control ECU Assembly [Driver Side]) |
Disconnect the T7*1 and T8*1 or S7*2 and S8*2 position control ECU assembly (driver seat) connectors.
*1: for LHD
*2: for RHD
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| T7-3 (+B) - Body ground | Power switch off | 11 to 14 V |
| T8-15 (SYSB) - Body ground | Power switch off | 11 to 14 V |
| T8-1 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| T8-1 (IG) - Body ground | Power switch off | Below 1 V |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| S7-3 (+B) - Body ground | Power switch off | 11 to 14 V |
| S8-15 (SYSB) - Body ground | Power switch off | 11 to 14 V |
| S8-1 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| S8-1 (IG) - Body ground | Power switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front power seat switch (driver seat).
Inspect the front power seat switch (driver seat).
Click hereVehicle Interior>SEAT>POWER SEAT SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the T14*1 or S14*2 front power seat switch (driver seat) connector.
Disconnect the T8*1 or S8*2 position control ECU assembly (driver seat) connectors.
*1: for LHD
*2: for RHD
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T14-20 (E) - T8-12 (SGND) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S14-11 (E) - S8-12 (SGND) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG