The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below.
Use the same procedure as for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
78010F
1.REMOVE ACCELERATOR PEDAL ASSEMBLY (for LHD)
for HV Model:
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>ACCELERATOR PEDAL SENSOR>REMOVAL
for A25A-FKS:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
for M20A-FKS:
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
88650N
2.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
for LHD:
| *a | Clamp |
| *b | Guide |
Detach the clamp.
Remove the screw.
Detach the guide.
Detach the guide.
| *A | for Type A | *B | for Type B |
|
Remove in this Direction | - | - |
Pull out the air conditioning amplifier assembly as shown in the illustration.
for RHD:
Remove the screw.
| *A | for Type A | *B | for Type B |
|
Remove in this Direction | - | - |
Detach the guide.
Pull out the air conditioning amplifier assembly as shown in the illustration.
| *A | for Type A |
| *B | for Type B |
Disconnect each connector and remove the air conditioning amplifier assembly.