The hybrid vehicle control ECU assembly monitors the voltage of the HV battery. The hybrid vehicle control ECU assembly stops compressor control and stores this DTC when the monitored voltage is outside the specified range.
This DTC will be stored as a history DTC. Compressor control may not resume unless the power switch is turned off.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B1471 | A/C Inverter High Voltage Power Resource System Malfunction | ·
Diagnosis condition: Power switch on (READY) ·
Malfunction status: Open or short in A/C inverter high voltage power resource system ·
Detection time: None |
·
CAN communication system ·
Hybrid control system ·
HV air conditioning wire ·
Air conditioning wire ·
Compressor with motor assembly |
Memorized |
Wear insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Carry the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
Inspect the fuses for circuits related to this system before performing the following procedure.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
The hybrid control system and air conditioning system output DTCs separately. Perform troubleshooting for the hybrid control system first if DTCs from these systems are output simultaneously.
Using the GTS, check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output | B |
A
B
Check if hybrid control system DTCs are output.
Click here
Hybrid control system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Be sure to wear insulated gloves.
Disconnect the Z1 and Z2 HV air conditioning wire connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Z1-2 (PB) - Z2-1 (ACPB) | Always | Below 1 Ω |
| Z1-1 (PE) - Z2-2 (ACPE) | Always | Below 1 Ω |
| Z1-2 (PB) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG