The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during motor cooling cooler removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
for 2WD:
for 4WD/AWD:
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
If the ECM has been struck or dropped, replace it.
for A25A-FXS:
Perform Vehicle Identification Number (VIN) registration when replacing the ECM.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>REGISTRATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>REGISTRATION
for A25B-FXS:
Perform Vehicle Identification Number (VIN) registration when replacing the ECM.
Click hereEngine / Hybrid System>A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>REGISTRATION
G9200
1.REMOVE INVERTER WITH CONVERTER ASSEMBLY
53896B
2.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
53895B
3.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
51420
5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
53737D
6.REMOVE FRONT FENDER APRON SEAL LH
G9225K
7.REMOVE NO. 1 INVERTER COOLING HOSE
Slide the clip and remove the No. 1 inverter cooling hose from the motor cooling cooler.
G9229A
8.DISCONNECT NO. 5 INVERTER COOLING HOSE
G125A
9.REMOVE MOTOR COOLING COOLER
| *1 | Oil Cooler Union Bolt |
| *2 | No. 1 Oil Cooler Tube Clamp |
Remove the oil cooler union bolt and gasket to disconnect the No. 2 motor cooling pipe from the hybrid vehicle transaxle assembly.
Remove the bolt and No. 1 oil cooler tube clamp to disconnect No. 2 motor cooling pipe from the hose bracket.
Remove the 3 bolts to disconnect the motor cooling cooler from the No. 1 transmission control cable bracket.
Use a container to catch any coolant and hybrid transaxle fluid which flow out of the motor cooling cooler.
Slide the clip and disconnect the No. 1 motor cooling hose from the transaxle housing tube connector.
Make sure not to remove the No. 1 motor cooling hose from the motor cooling cooler as the motor cooling cooler may be deformed.
G1252A
10.REMOVE NO. 2 MOTOR COOLING PIPE
Slide the clip and remove the No. 2 motor cooling pipe from the No. 2 motor cooling hose.
Make sure not to remove the No. 2 motor cooling hose from the motor cooling cooler as the motor cooling cooler may be deformed.