Home › General › MAINTENANCE › REAR BRAKE FLEXIBLE HOSE › from 2019.02
RM3620E _V1 General _076298 MAINTENANCE _0374945 REAR BRAKE FLEXIBLE HOSE A

MAINTENANCE  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the rear flexible hoses.

·

When reusing the rear flexible hoses, use the identification marks created during removal to install each rear flexible hose to its original position.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE LH

NOTICE:

When installing the rear flexible hose LH, minimize twisting of the hose.


a.
C408224C01
1.146,2.198 1.344,1.708 1.344,1.708 1.531,1.708 true 0.688,0.75 0.688,0.344 0.688,0.344 0.563,0.344 true 1.573,0.302 1.885,0.458 0.313,0.156 10 false *b 1.604,1.635 1.823,1.823 0.219,0.188 10 true *a 0.375,0.25 0.688,0.406 0.313,0.156 10 false *c
*a Identification Mark
*b Torque Wrench Fulcrum Length
*c Union Nut Wrench


Install the rear flexible hose LH with a new clip.

NOTICE:
·

Install the clip as far as it will go.

·

When installing the rear flexible hose LH, face the identification mark to the upper side of the vehicle.




b.

Using a union nut wrench, connect the brake line to the rear flexible hose LH while holding the rear flexible hose LH with a wrench.

Torque:
Specified tightening torque : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):

13.4 N*m (137 kgf*cm, 10 ft.*lbf)




c.

Install the rear flexible hose LH to the rear flexible hose bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


d.

Install the rear flexible hose LH to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTICE:

Install the rear flexible hose LH lock securely into the lock hole in the rear disc brake cylinder assembly.



Hide 2.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/o Vacuum Brake Booster)

a.

Connect the reservoir level switch connector.


b.

Connect the cable to the negative (-) auxiliary battery terminal.

Click hereBrake>BRAKE (REAR)>REAR BRAKE>INSTALLATION


c.

Turn the power switch on (READY).


d.

Depress the brake pedal and release it.



Hide 3.BLEED BRAKE LINE

Hide 4.INSTALL REAR WHEEL