If the hybrid vehicle control ECU assembly receives a signal from the skid control ECU assembly that the AWD system is malfunctioning, the hybrid vehicle control ECU assembly outputs this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Warning Indicate |
|---|---|---|---|---|---|
| C134800 | Different Diameter Tire | The vehicle is being driven in a straight line at a constant speed of 30 km/h (19 mph) or more, and the wheel speeds differ between front and rear significantly.
(1 trip detection logic) |
·
Tire and wheel size ·
Tire pressure ·
Speed sensor circuit ·
Hybrid vehicle control ECU assembly |
Does not come on | Master Warning:
Does not come on |
Check the size and condition of all four wheels.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
The DTC is output when tire deformation or a difference in tire size is detected.
Adjust the air pressure in the tires.
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Turn the power switch on (READY).
Drive the vehicle at a speed of 30 km/h (19 mph) or more.
Check if the same DTC is output.
Check that no speed sensor DTCs are output.
If C134800 and electronically controlled brake system DTCs are output simultaneously, check and repair the trouble areas in the electronically controlled brake system.
When a DTC has been stored, the vehicle condition when the DTC was stored can be determined from the freeze frame data.
Electronically Controlled Brake System:
| Result | Proceed to |
|---|---|
| DTC C134800 and speed sensor DTC are not output. | A |
| Speed sensor DTC is output. | B |
| DTC C134800 is output. | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C