Home › Engine / Hybrid System › A25A-FKS (EMISSION CONTROL) › EGR VALVE › from 2020.08
RM3620E _51 Engine / Hybrid System _076502 A25A-FKS EMISSION CONTROL _0372396 EGR VALVE A

A25A-FKS EMISSION CONTROL  EGR VALVE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 25620 1.INSTALL EGR VALVE ASSEMBLY

a.

Using an 8 mm socket wrench, install the EGR valve assembly to the EGR valve bracket with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.
A473008C02
2.26,1 2.76,0.656 2.76,0.656 2.885,0.656 true 2.292,1.083 2.51,1.083 true 2.573,0.99 2.885,1.188 0.313,0.198 10 true *a 2.927,0.542 3.24,0.74 0.313,0.198 10 true *b
*a Pin
*b Hole


Align and fit the hole of the EGR valve bracket to the pin of the camshaft housing.


c.

Using the 8 mm socket wrench, install the EGR valve assembly with the EGR valve bracket to the camshaft housing with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Install the EGR cooler bracket to the EGR valve bracket and water outlet with the 2 bolts.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


e.

Install the No. 4 water by-pass hose to the EGR valve assembly and slide the clip to secure it.


f.

Connect the No. 8 water by-pass hose to the EGR valve assembly and slide the clip to secure it.


Hide 25601 2.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY

a.

Install a new EGR inlet gasket to the intake manifold.


b.

Install a new EGR valve adapter gasket to the No. 1 EGR pipe sub-assembly.


c.

Using an 8 mm socket wrench, install the No. 1 EGR pipe sub-assembly to the intake manifold and EGR valve assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 3.CONNECT ENGINE WIRE

a.
A402225C01
0.875,0.042 1.083,0.24 0.208,0.198 10 true *a 2.844,0.323 3.063,0.521 0.219,0.198 10 true *b
*a No. 5 Engine Wire Connector
*b EGR Valve Assembly Connector


Engage the 2 wire harness clamps to connect the engine wire.


b.

Install the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the EGR valve assembly connector.


d.

Connect the No. 5 engine wire connector.


Hide 5.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 12601B 6.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY