The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
17111
4.REMOVE INTAKE MANIFOLD
23901
5.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Disconnect the fuel tube sub-assembly from the fuel pump assembly.
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
23801P
6.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
Disconnect the connector from the ignition coil assembly.
Remove the bolt and disconnect the No. 1 fuel pipe sub-assembly from the cylinder head sub-assembly.
|
Union Bolt |
|
Bolt |
Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
Remove the bolt.
Loosen the 2 bolts of the fuel pump assembly.
Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe and fuel pump assembly.
23100X
7.REMOVE FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY
When replacing the fuel pump assembly, it is necessary to replace the No. 1 fuel pipe sub-assembly with a new one.
Disconnect the connector from the fuel pump assembly.
Remove the 2 bolts, fuel pump assembly and fuel pump flange from the cylinder head cover sub-assembly.
Remove the O-ring from the fuel pump assembly.
Remove the fuel pump lifter assembly from the fuel pump lifter guide.
Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.