Home › Engine / Hybrid System › A25A-FKS (COOLING) › WATER PUMP › from 2020.08
RM3620E _51 Engine / Hybrid System _076659 A25A-FKS COOLING _0373119 WATER PUMP A

A25A-FKS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)
·

Replacement of throttle body with motor assembly

·

Replacement of EGR valve assembly

·

Gas leaks from exhaust system


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


w/ Canister Pump Module:(Click here)
w/o Canister Pump Module:(Click here)

NOTICE:
·

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

·

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16032 2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A434808

Disconnect the sensor wire connector.


b.
A434809

Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).


c.
A434810

Disconnect the engine water pump assembly (water inlet housing) connector.


d.
A434811

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.


e.
A402026

Remove the gasket from the engine water pump assembly (water inlet housing).