Home › Drivetrain › P710 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT PADDLE SWITCH › from 2020.08
RM3620E _52 Drivetrain _076274 P710 HYBRID TRANSMISSION / TRANSAXLE _0371345 SHIFT PADDLE SWITCH A

P710 HYBRID TRANSMISSION / TRANSAXLE  SHIFT PADDLE SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for HV model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for HV model) (Click here)
Reset back door close position Power back door system (for HV model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.


PROCEDURE

Hide 45100 1.REMOVE STEERING WHEEL ASSEMBLY

Hide 84250A 2.REMOVE STEERING PAD SWITCH ASSEMBLY

Hide 84610G 3.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

a.
C402734

Remove the 2 screws.


b.
C402735

Disengage the 4 claws.


c.
C402736

Disengage the 2 clamps to disconnect the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly from the steering wheel assembly.


d.
C402737

Disconnect the No. 1 transmission shift switch assembly connector and No. 2 transmission shift switch assembly connector to remove the No. 1 transmission shift switch assembly and No. 2 transmission shift switch assembly from the No. 1 switch wire.


Hide 84523 4.REMOVE NO. 1 SWITCH WIRE

HINT:

Perform this procedure only when replacement of the No. 1 switch wire is necessary.


a.
C402738

Disengage the 2 guides and remove the No. 1 switch wire from the steering wheel assembly.