The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
73900
2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
87211A
3.REMOVE NO. 2 AIR DUCT
84340
4.REMOVE STOP LIGHT SWITCH ASSEMBLY
84345
5.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
47110
6.DISCONNECT BRAKE PEDAL SUPPORT ASSEMBLY
Disconnect the connector and disengage the 2 clamps.
Remove the bolt and disconnect the brake pedal support assembly from the instrument panel reinforcement assembly.
47101A
7.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support assembly.
8.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
47264A
9.REMOVE PUSH ROD PIN
Remove the clip and push rod pin.
47110
10.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
w/ clip:
Remove the 2 clips from the brake pedal support assembly.
Remove the 4 nuts and brake pedal support assembly.
47121
11.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad from the brake pedal support assembly.