Home › Power Source / Network › A25A-FKS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.08
RM3620E _57 Power Source / Network _076183 A25A-FKS BATTERY / CHARGING _0371286 BATTERY CURRENT SENSOR A

A25A-FKS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery state sensor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedures Necessary Procedures Effects / Inoperative when not performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system (for Gasoline model)*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (for Gasoline model) (Click here)
Reset back door close position Power back door system (for Gasoline model) (Click here)
Power back door initialization Power door lock control system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850C 2.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A437087

Remove the nut to disconnect the engine wire and ground wire from the battery state sensor assembly.


b.
A432031

Loosen the nut and disconnect the battery state sensor assembly from the battery.


c.
A432032

Disconnect the battery state sensor assembly connector.


d.

Detach the clamp and disconnect the engine wire from the battery state sensor assembly.


e.
A432033

Detach the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.