The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
58410B
2.REMOVE DECK BOARD ASSEMBLY
58416K
3.REMOVE REAR NO. 2 FLOOR BOARD
65351A
4.REMOVE BATTERY HOLE COVER
28850C
5.REMOVE BATTERY STATE SENSOR ASSEMBLY
Remove the nut and disconnect the No. 2 frame wire from the battery state sensor assembly.
When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.
Disconnect the battery state sensor assembly connector.
Detach the clamp and disconnect the engine wire from the battery state sensor assembly.
Detach the 2 claws to remove the battery state sensor assembly from the battery current sensor holder.