The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ECM removal/installation are shown below.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
If the ECM has been struck or dropped, replace it.
Perform Vehicle Identification Number (VIN) registration when replacing the ECM.
w/ Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>REGISTRATION
w/o Canister Pump Module:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>REGISTRATION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY
4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
89661
5.REMOVE ECM
Rotate the 3 levers while pushing the locks, and disconnect the 3 ECM connectors.
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the 2 bolts, nut and ECM.
If the ECM has been struck or dropped, replace it.
89667E
6.REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket from the ECM.
89668
7.REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket from the ECM.