The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28100
1.REMOVE STARTER ASSEMBLY
w/ Stop And Start System:
Click hereEngine / Hybrid System>A25A-FKS (STARTING)>STARTER (w/ Stop And Start System)>REMOVAL
for VALEO Made:
Click hereEngine / Hybrid System>A25A-FKS (STARTING)>STARTER (for VALEO Made)>REMOVAL
11401G
2.REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
If the crankshaft position sensor has been struck or dropped, replace it.