Home › Engine / Hybrid System › STOP AND START › BACKUP BOOST CONVERTER › from 2020.08
RM3620E _51 Engine / Hybrid System _076400 STOP AND START _0371971 BACKUP BOOST CONVERTER A

STOP AND START  BACKUP BOOST CONVERTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during eco-run vehicle converter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: When performing learning using the GTS.

Click here(Click here)

Battery terminal is disconnected/reconnected Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system
·

for A25A-FKS:

(Click here)

·

for M20A-FKS:

(Click here)


Perform steering sensor zero point calibration Lane control system (Click here)
Parking support brake system*
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
Reset back door close position Power back door system (Click here)
Power back door initialization Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide G92C0A 4.REMOVE ECO-RUN VEHICLE CONVERTER ASSEMBLY

a.
A428811C01
1.042,3.896 1.25,4.25 1.25,4.25 1.417,4.25 true 2.5,3.25 2.25,2.833 2.25,2.833 2.083,2.833 true 1.458,4.146 1.771,4.302 0.313,0.156 10 false *a 1.885,2.729 2.198,2.885 0.313,0.156 10 false *a
*a Lock Lever


Move the lock lever and disconnect the connector from the eco-run vehicle converter assembly.


b.
A428813

Remove the 2 nuts and eco-run vehicle converter assembly.


Hide F1334 5.REMOVE NO. 1 CONVERTER CONTROL BRACKET

a.
A428814

Remove the 2 bolts and No. 1 converter control bracket from the eco-run vehicle converter assembly.