82821K
1.REMOVE CONNECTOR COVER (w/o Wire Harness)
Detach the clamp and remove the connector cover.
2.REMOVE FOG LIGHT SEAL (w/o TOYOTA Parking Assist-sensor System)
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Remove the fog light seal.
85354
3.REMOVE HEADLIGHT WASHER COVER LH (w/ Headlight Cleaner System)
85353
4.REMOVE HEADLIGHT WASHER COVER RH (w/ Headlight Cleaner System)
Use the same procedure described for the LH side.
85208A
5.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
85207A
6.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure described for the LH side.
85271
7.REMOVE NO. 1 HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)
Detach the clamp and remove the No. 1 headlight cleaner hose.
82114
8.REMOVE NO. 4 ENGINE ROOM WIRE (w/ Wire Harness)
w/o Toyota Parking Assist-sensor System:
Disconnect each connector.
| *A | w/ Fog Light | *B | w/ Dynamic Radar Cruise Control System |
Detach the clamp and remove the No. 4 engine room wire.
w/ Toyota Parking Assist-sensor System, w/o Parking Support Brake System:
Disconnect each connector.
| *A | w/ Panoramic View Monitor System | *B | w/ Dynamic Radar Cruise Control System |
Detach the clamp and remove the No. 4 engine room wire.
w/ Toyota Parking Assist-sensor System, w/ Parking Support Brake System:
Disconnect each connector.
| *A | w/ Panoramic View Monitor System | - | - |
Detach the clamp and remove the No. 4 engine room wire.
89348X
9.REMOVE FRONT ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)
89341K
10.REMOVE FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341L
11.REMOVE FRONT CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89347B
12.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
88211B
13.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)
14.REMOVE NUT
|
Remove in this Direction |
Remove the 2 nuts.
52114A
15.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET
for Type A:
Remove the 2 screws.
|
Remove in this Direction |
Detach the claw and guide to remove the front bumper extension mounting bracket as shown in the illustration.
for Type B:
Remove the 2 screws.
|
Remove in this Direction |
Detach the guide to remove the front bumper extension mounting bracket as shown in the illustration.
for Type C:
Remove the 2 screws and front bumper extension mounting bracket.
81220
16.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
81210A
17.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
53395E
18.REMOVE FRONT HOOD TO END PANEL SEAL
|
Remove in this Direction |
Detach the clip and remove the front hood to end panel seal.
53115B
19.REMOVE RADIATOR GRILLE BRACKET
|
Screw |
|
Clip (A) |
|
Clip (B) |
Remove the 2 screws.
Remove the 4 clips (A).
Remove the 2 clips (B) and detach the guide.
|
Remove in this Direction |
Remove the 8 screws.
Detach the claw and remove the radiator grille bracket.
53124B
20.REMOVE RADIATOR GRILLE SIDE MOULDING LH
|
Remove in this Direction |
Detach the claw and remove the radiator grille side moulding LH.
53123B
21.REMOVE RADIATOR GRILLE SIDE MOULDING RH
Use the same procedure as for the LH side.
52128B
22.REMOVE FRONT BUMPER HOLE COVER LH
w/ Fog Light:
|
Remove in this Direction |
Remove the clip.
Detach the claw and remove the front bumper hole cover LH.
w/o Fog Light:
|
Remove in this Direction |
Remove the clip.
Detach the claw and remove the front bumper hole cover LH.
52127D
23.REMOVE FRONT BUMPER HOLE COVER RH
Use the same procedure as for the LH side.
75311
24.REMOVE RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
|
Remove in this Direction |
Remove the 2 screws.
Detach the claw and guide and remove the radiator grille (or front panel) emblem.
53286C
25.REMOVE FRONT BUMPER ARM HOLE COVER LH
|
Remove in this Direction |
Detach the claw.
|
Fall Prevention Hook |
Detach the fall prevention hook and remove the front bumper arm hole cover LH.
53285J
26.REMOVE FRONT BUMPER ARM HOLE COVER RH
Use the same procedure as for the LH side.
52438
27.REMOVE FRONT BUMPER GUARD COVER LH
|
Remove in this Direction |
Detach the claw.
|
Fall Prevention Hook |
Detach the fall prevention hook and remove the front bumper guard cover LH.
52437
28.REMOVE FRONT BUMPER GUARD COVER RH
Use the same procedure as for the LH side.
52411
29.REMOVE FRONT BUMPER GUARD
Remove the 6 outside moulding retainers.
Remove the 2 screws.
Detach the claw and guide to remove the front bumper guard as shown in the illustration.
|
Remove in this Direction | - | - |
52711
30.REMOVE FRONT BUMPER MOULDING (for Separate Type)
Remove the 2 screws.
|
Remove in this Direction |
Detach the claw and remove the front bumper moulding as shown in the illustration.
53113E
31.REMOVE LOWER NO. 2 RADIATOR GRILLE
Remove the 2 screws.
|
Remove in this Direction |
Detach the claw and remove the lower No. 2 radiator grille as shown in the illustration.
53112A
32.REMOVE LOWER RADIATOR GRILLE