The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during millimeter wave radar sensor assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY (w/ NO. 1 Radiator to Support Seal)
| *1 | No. 1 Radiator To Support Seal |
For vehicles with the No. 1 radiator to support seal installed, remove the front bumper assembly.
Remove the front bumper assembly.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Off Road Package)>REMOVAL
17750A
2.REMOVE INLET AIR CLEANER ASSEMBLY (for Gasoline Model, w/o NO. 1 Radiator to Support Seal)
53510
3.REMOVE HOOD LOCK ASSEMBLY (w/o NO. 1 Radiator to Support Seal)
16681A
4.REMOVE RADIATOR UPPER AIR GUIDE PLATE (w/o NO. 1 Radiator to Support Seal)
88211B
5.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.
| *A | except Off Road Package |
| *B | for Off Road Package |
Disconnect the connector.
| *A | except Off Road Package |
| *B | for Off Road Package |
|
Bolt |
|
Screw |
Remove the 2 bolts and screw.
Detach the guide and remove the millimeter wave radar sensor assembly.