Home › Engine / Hybrid System ยท CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the cruise control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.PROBLEM SYMPTOM CONFIRMATION

      NEXT


      3.CHECK CAN COMMUNICATION SYSTEM*
      1. Check for output DTCs.
        Result: 
        Proceed to
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output
        B

        HINT:
        The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.



      B.
      GO TO CAN COMMUNICATION SYSTEM (Click here).
      A


      4.DTC CHECK AND CLEAR*
        Refer to DTC Check/Clear (Click here).

      NEXT


      5.DTC CHECK (OTHER THAN CAN SYSTEM DTC)*
        Result: 
        Result
        Proceed to
        DTC is not output
        A
        DTC is output
        B


      B.
      GO TO DTC CHART (Click here).
      A


      6.PROBLEM SYMPTOM CONFIRMATION
        Result: 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B


      B.
      Go to STEP 9
      A


      7.SYMPTOM SIMULATION
        Refer to Electronic Circuit Inspection Procedure (Click here).

      NEXT


      8.PROBLEM SYMPTOMS TABLE
        Refer to Problem Symptoms Table (Click here).

      NEXT


      9.CIRCUIT INSPECTION

        NEXT


        10.TERMINALS OF ECM
          Refer to Terminals of ECM (Click here).

        NEXT


        11.IDENTIFICATION OF PROBLEM

          NEXT


          12.REPAIR OR REPLACE

            NEXT


            13.CONFIRMATION TEST

              NEXT

              END