DYNAMIC LASER CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit |
| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
Check the CRUISE main indicator light by performing the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Indicat. Lamp Cruise | Cruise main indicator light | BLINK/OFF | - |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Laser Cruise / Data List.
Check the Data List for proper functioning of the CRUISE main indicator light.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Ready M-CPU | Cruise control system standby condition (Main CPU) / ON or OFF | Each time main switch is pushed, ON/OFF changes | "1" |
| CCS Indicator M-CPU | Cruise indicator signal (Main CPU) / ON or OFF | ON: "CRUISE" ON OFF: "CRUISE" OFF | "2" |
| Result | Proceed to |
| OK | A |
| NG (for 2UZ-FE) | B |
| NG (for 3UR-FE) | C |
| NG (for 3UR-FBE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||