DTC P1615 Communication Error from Distance Control ECU to ECM |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1615 | While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is logically inconsistent for 0.5 seconds, the ECM records this logical error code |
|
| 1.REPLACE DISTANCE CONTROL ECU |
| NEXT | |
| 2.PERFORM INITIALIZATION |
Perform initialization (Click here).
Turn the ignition switch to ON.
Turn the cruise control main switch on.
With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.
| NEXT | |
| 3.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Reproduce the DTC detection conditions under which the DTC is stored.
Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for 2UZ-FE) | B |
| DTC is output (for 3UR-FE) | C |
| DTC is output (for 3UR-FBE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||