Home › Engine / Hybrid System ยท CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1616    Communication Error from ECM to Distance Control ECU

for Preparation Click here


DESCRIPTION

The ECM receives signals from each sensor and ECU, and then sends signals such as A/T signals, cruise control operation signals, low speed operation signals, brake control operation signals, and laser light emission prohibiting signals, to the distance control ECU. The ECM is the only component that has a function to record and output the DTCs in the dynamic laser cruise control system. Therefore, if the distance control ECU detects a communication error from the ECM, it sends a malfunction signal back to the ECM.

DTC No.
DTC Detection Condition
Trouble Area
P1616
While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a logical error signal from the distance control ECU for 0.15 seconds, the ECM records this logical error code
  1. Communication circuit
  2. ECM
  3. Distance control ECU

INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

NOTICE:
When the distance control ECU and ECM is replaced with a new one, initialization must be performed (Click here).

1.REPLACE ECM
  1. Replace the ECM.

    1. for 2UZ-FE (Click here).
    2. for 3UR-FE (Click here).
    3. for 3UR-FBE (Click here).


NEXT


2.PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    1. Turn the ignition switch to ON.

    2. Turn the cruise control main switch on.

    3. With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.

      NOTICE:
      1. Do not turn the light control switch on at this time because the beam axis automatic adjustment mode has already started, which could lead to incorrect beam axis. If the light control switch is turned on by mistake, readjust the beam axis (refer to Beam Axis Adjustment) (Click here).
      2. If initialization cannot be performed, first inspect the stop light switch circuit, cruise main switch circuit, and skid control buzzer circuit.


NEXT


3.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Reproduce the DTC detection conditions under which the DTC is stored.

    HINT:
    If the DTC detection conditions are not correct, the system will not detect the trouble.

  1. Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.

  1. Check for DTCs (Click here).

    OK:
    P1616 is not output.



NG
REPLACE DISTANCE CONTROL ECU
OK

END