DTC P1617 Distance Control ECU Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1617 | While the dynamic laser cruise control is either preparing for operation or operating, if a designation signal from the ECM and a designation return signal from the distance control ECU do not match or the distance control ECU is malfunctioning for 0.3 seconds, the ECM records this trouble code | Distance control ECU |
| 1.PERFORM INITIALIZATION |
Perform initialization (Click here).
Turn the ignition switch to ON.
Turn the cruise control main switch on.
With the brake pedal depressed, push the cruise control main switch to + (ACCEL)/RES (RESUME) 3 times within 3 seconds. Check that the skid control buzzer sounds at this time.
|
| ||||
| OK | |
| 2.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Reproduce the DTC detection conditions under which the DTC is stored.
Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.REPLACE DISTANCE CONTROL ECU |
Replace the distance control ECU (Click here).
| NEXT | |
| 5.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 6.CHECK FOR DTC |
Reproduce the DTC detection conditions under which the DTC is stored.
Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.
Check for DTCs (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output (for 2UZ-FE) | B |
| DTC is output (for 3UR-FE) | C |
| DTC is output (for 3UR-FBE) | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||