Home › Engine / Hybrid System ยท CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1630    Communication Error from VSC to ECM

for Preparation Click here


DESCRIPTION

The skid control ECU sends signals such as cruise control cancel demand signals and brake operation demand (from ECM) response signals to the ECM when the dynamic laser cruise control system is in operation.

DTC No.
DTC Detection Condition
Trouble Area
P1630
While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the skid control ECU is logically inconsistent for 0.5 seconds, the ECM records this logical error code
  1. Communication circuit
  2. Skid control ECU
  3. ECM

INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

NOTICE:
When the distance control ECU and ECM is replaced with a new one, initialization must be performed (Click here).

1.REPLACE SKID CONTROL ECU
Replace the skid control ECU (Click here).

NEXT


2.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


3.CHECK FOR DTC
  1. Reproduce the DTC detection conditions under which the DTC is stored.

    HINT:
    If the DTC detection conditions are not correct, the system will not detect the trouble.

  1. Drive the vehicle at a speed of 45 km/h (28 mph) or more and turn the cruise control main switch ON. Push the -SET switch to activate the cruise control system.

  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for 2UZ-FE)
    B
    DTC is output (for 3UR-FE)
    C
    DTC is output (for 3UR-FBE)
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A

END