Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter

for Preparation Click here


DESCRIPTION

This circuit is necessary for the ASL (Auto Sound Leveliser) built into the stereo component amplifier assembly. Speed signals are received from the combination meter assembly and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable the driver to hear clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up, etc.).

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM


E130075E25


INSPECTION PROCEDURE

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter assembly is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    1. The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.
    2. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to "Operation Check" in the meter/gauge system (Click here).



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    E160663E01
  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Jack up the drive wheels.

  1. Move the shift lever to N.

  1. Turn the ignition switch to ON.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Waveform 
    Terminal Connections
    I17-11 (SPD) - Body ground
    Tester Range
    5 V/DIV., 20 msec./DIV.
    Vehicle Condition
    Drive vehicle at 20 km/h (12 mph)

    HINT:
    As the vehicle speed increases, the wavelength shortens.

    OK:
    Voltage pulses as shown in the illustration.

  1. Reconnect the stereo component amplifier assembly connector.



NG
Go to step 3
OK

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)  

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - STEREO COMPONENT AMPLIFIER)


    E145925E02
  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Disconnect the H37 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    I17-11 (SPD) - H37-35 (+S)
    Always
    Below 1 Ω
    I17-11 (SPD) - Body ground
    Always
    10 kΩ or higher

    HINT:
    If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or an ECU that is connected to the SPD signal wire.

  1. Reconnect the stereo component amplifier assembly connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)