Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is normal, no sound, or only an extremely small sound, can be produced.

WIRING DIAGRAM


E130075E24


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    E121567E05
  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    I17-1 (MUTE) - Body ground
    Ignition switch ACC, Audio system is playing → Changing modes
    Above 3.5 V → Below 1 V

  1. Reconnect the stereo component amplifier connector.



NG
Go to step 2
OK

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)


    E160624E02
  1. Disconnect the I4 radio receiver assembly connector.

  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I4-7 (MUTE) - I17-1 (MUTE)
    Always
    Below 1 Ω
    I4-7 (MUTE) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the radio receiver assembly connector.

  1. Reconnect the stereo component amplifier assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE RADIO RECEIVER ASSEMBLY (Click here)