DTC 01-D6 No Master |
DTC 01-D7 Connection Check Error |
| DTC Code | DTC Detection Condition | Trouble Area |
| 01-D6*1 | When either of the following conditions is met:
|
|
| 01-D7*2 | When either of the following conditions is met:
|
| 1.CHECK NAVIGATION RECEIVER ASSEMBLY POWER SOURCE CIRCUIT |
Refer to the navigation receiver power source circuit (Click here).
If the power source circuit is operating normally, proceed to the next step.
| NEXT | |
| 2.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
![]() |
Enter the diagnostic mode.
Press the "LAN Mon" switch to change to "LAN Monitor" mode.
Identify the component which has stored this code.
| Display | Component |
| AVN | Navigation receiver assembly |
| DSP-AMP | Stereo component amplifier assembly |
| Rr-TV* | Television Display assembly |
| NEXT | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT WHICH HAS STORED THIS CODE |
Inspect the power source circuit of the component which has stored this code.
| Component | Proceed to |
| Navigation receiver (AVN) | Navigation receiver power source circuit (Click here) |
| Stereo component amplifier (DSP-AMP) | Stereo component amplifier power source circuit (Click here) |
| Television display (Rr-TV)* | Television display power source circuit (Click here) |
| NEXT | |
| 4.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the I20 and I25* navigation receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I20-5 (ATX+) - I20-15 (ATX-) | Always | 60 to 80 Ω |
| I25-9 (TXM+) - I25-10 (TXM-)* |
Reconnect the navigation receiver assembly connectors.
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver and the component which has stored this code.
Disconnect all connectors between the navigation receiver and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the navigation receiver and the component which has stored this code.


|
| ||||
| OK | |
| 6.REPLACE COMPONENT WHICH HAS STORED THIS CODE |
Replace the component which has stored this code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||