DTC 01-DF Master Error |
| DTC Code | DTC Detection Condition | Trouble Area |
| 01-DF* | The device with a display fails and the master is switched to the audio device. Also when a communication error between the sub-master (audio) and master occurs, this code is stored. |
|
| 1.CHECK RADIO RECEIVER POWER SOURCE CIRCUIT |
Refer to Radio Receiver Power Source Circuit (Click here).
| NEXT | |
| 2.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Disconnect the I4 and I8* radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I4-5 (ATX+) - I4-15 (ATX-) | Always | 60 to 80 Ω |
| I8-9 (TXM+) - I8-10 (TXM-)* | Always | 60 to 80 Ω |
Reconnect the radio receiver assembly connector.
|
| ||||
| OK | |
| 3.IDENTIFY COMPONENT WHICH HAS STORED THIS CODE |
Enter the diagnostic mode.

Press the preset switch "3" to change to "Detailed Information Mode".
Identify the component which has stored this code.
| Component | Physical Address |
| Stereo component amplifier | 440 |
| "Bluetooth" handsfree module | 19D |
| Television display* | 1B0 |
| NEXT | |
| 4.CHECK COMPONENT WHICH HAS STORED THIS CODE |
Select the component which has stored this code.
| Component | Proceed to |
| Except "Bluetooth" handsfree module | A |
| "Bluetooth" handsfree module (for Column Shift Type) | B |
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) |

Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
Disconnect all connectors between the radio receiver assembly and the component which has stored this code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and the component which has stored this code.
|
| ||||
| OK | |
| 6.REPLACE RADIO RECEIVER ASSEMBLY |
Replace the radio receiver assembly (Click here).
|
| ||||
| OK | ||
| ||