DTC B1242 Wireless Door Lock Tuner Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1242 | In diagnostic mode, an applicable RDA signal cannot be received within 1 second after an PRG signal has been output from the main body ECU. |
|

| 1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - DOOR CONTROL RECEIVER) |
![]() |
Disconnect the H3 main body ECU connector and the O25 door control receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H3-12 (RDA) - O25-2 (RDA) | Always | Below 1 Ω |
| H3-12 (RDA) - Body ground | Always | 10 kΩ or higher |
| H3-10 (PRG) - O25-3 (PRG) | Always | Below 1 Ω |
| H3-10 (PRG) - Body ground | Always | 10 kΩ or higher |
Reconnect the main body ECU connector and the door control receiver connector.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BATTERY, BODY GROUND) |
![]() |
Disconnect the O25 door control receiver connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O25-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| O25-5 (+B) - Body ground | Always | 11 to 14 V |
Reconnect the door control receiver connector.
|
| ||||
| OK | |
| 3.REPLACE DOOR CONTROL RECEIVER |
Replace the door control receiver with a normal one (Click here).
| NEXT | |
| 4.REGISTER RECOGNITION CODE |
Perform the registration procedures (Click here).
| NEXT | |
| 5.CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 6.CONFIRM DTC |
Check if the same DTC is detected.
|
| ||||
| OK | ||
| ||