AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.INSPECT COMBINATION METER ASSEMBLY (SPEED SIGNAL) |
![]() |
Disconnect the I3*1 or I9*2 radio receiver assembly connector.
Jack up the drive wheels.
Move the shift lever to N.
Turn the ignition switch to ON.
Using an oscilloscope, check the signal waveform of the combination meter assembly.
| Terminal Connection | I3-3 (SPD)*1 - Body ground I9-4 (SPD)*2 - Body ground |
| Tester Range | 5 V/DIV., 20 msec./DIV |
| Vehicle Condition | Drive vehicle at 20 km/h (12 mph) |
Reconnect the radio receiver assembly connector.
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - RADIO RECEIVER ASSEMBLY) |
![]() |
Disconnect the I3*1 or I9*2 radio receiver assembly connector.
Disconnect the H37 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-3 (SPD) - H37-35 (+S) | Always | Below 1 Ω |
| I3-3 (SPD) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| I9-4 (SPD) - H37-35 (+S) | Always | Below 1 Ω |
| I9-4 (SPD) - Body ground | Always | 10 kΩ or higher |
Reconnect the radio receiver assembly connector.
Reconnect the combination meter assembly connector.
|
| ||||
| OK | ||
| ||