Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1370/73    Engine or Transmission System Matching Error

for Preparation Click here


DESCRIPTION

This DTC is set by the skid control ECU when the ECM is replaced with one that has different engine and transmission information than the information stored in the skid control ECU.
This DTC is also set when the VSC actuator assembly (skid control ECU) is replaced with one that has different engine and transmission information than the information stored in the ECM.

DTC Code
DTC Detection Condition
Trouble Area
C1370/73
Information relating to engine, transmission, drive source or destination stored in ECM does not match information stored in skid control ECU.
  1. VSC actuator (skid control ECU)
  2. ECM

HINT:
If this DTC is output, clear the zero point calibration data and enter test mode (Click here). The system returns to normal when the correct data is received from the ECM.


INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.REPLACE ECM
  1. Replace the ECM for 2UZ-FE (Click here), 3UR-FE (Click here) or 3UR-FBE (Click here).


NEXT


2.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
END
A

REPLACE VSC ACTUATOR ASSEMBLY (Click here)