Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

POWER STEERING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the power steering system.
  2. *: Use a Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CUSTOMER PROBLEM ANALYSIS

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        NEXT


        5.CHECK CAN COMMUNICATION SYSTEM*
        1. Check for DTCs (Click here).
          Result 
          Result
          Proceed to
          CAN system DTC is not output
          A
          CAN system DTC is output
          B

          HINT:
          1. When any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.
          2. When communication to the power steering ECU is not established through a Techstream, inspect terminals CANH and CANL of the DLC3 and the power steering ECU, and the IG circuit of the power steering ECU.



        B.
        PROCEED TO CAN COMMUNICATION SYSTEM
        A


        6.CHECK VEHICLE STABILITY CONTROL SYSTEM*
        1. Check for DTCs (Click here).
          Result 
          Result
          Proceed to
          DTC output
          A
          DTC not output
          B

          HINT:
          When any vehicle stability control system DTCs are output, perform troubleshooting on the vehicle stability control system first.



        A.
        PROCEED TO VEHICLE STABILITY CONTROL SYSTEM
        B


        7.CHECK SFI SYSTEM*
        1. Check for DTCs.
          (3UR-FE: Click here)
          (3UR-FBE: Click here)
          (2UZ-FE: Click here)
          Result 
          Result
          Proceed to
          DTC output
          A
          DTC not output
          B

          HINT:
          When any SFI system DTCs are output, perform troubleshooting on the SFI system first.



        A.
        PROCEED TO SFI SYSTEM
        B


        8.PROBLEM SYMPTOMS TABLE
          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        Go to step 10
        A


        9.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. Terminals of ECU (Click here).


        NEXT


        10.REPAIR OR REPLACE

          NEXT


          11.CONFIRMATION TEST*

            NEXT

            END