Home › Power Source / Network · NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



BUS CHECK
  1. Select "CAN Bus Check" from the "System Select "screen on the Techstream.

    HINT:
    1. If any properly connected ECUs or sensors are not displayed, there is a communication stop in the system (Click here).
    2. Display the communication BUS check screen for approximately 1 minute and check for ECUs and sensors that are not indicated on the screen.


CHECK INSTALLED SYSTEMS (ECUS AND SENSORS) THAT ADOPT CAN COMMUNICATION
  1. Systems (ECUs and sensors) that adopt CAN communication vary depending on the vehicle optional settings. Check which systems (ECUs and sensors) are installed on the vehicle.

    ECU/Sensor Name
    Installed to
    Power steering ECU
    All vehicles
    Skid control ECU
    All vehicles
    Air conditioning amplifier
    All vehicles
    ECM
    All vehicles
    Main body ECU
    All vehicles
    Combination meter ECU
    All vehicles
    Center airbag sensor assembly
    All vehicles
    Steering angle sensor
    All vehicles
    Bus buffer ECU
    Vehicles with bus buffer ECU (w/ Bus buffer ECU)
    4WD control ECU
    Vehicles with 4 wheel drive (w/ 4WD)
    Power seat control ECU
    Vehicles with front power seat control system (w/ Seat memory)
    Outer mirror control ECU
    Vehicles with front power seat control system (w/ Seat memory)
    Multiplex tilt and telescopic ECU
    Vehicles with front power seat control system (w/ Seat memory)
    Air suspension ECU
    Vehicles with air suspension system
    Distance control ECU
    Vehicles with dynamic laser cruise control system
    Power back door ECU
    Vehicles with power back door system


DTC TABLE BY ECU

HINT:
  1. In the CAN communication system, CAN communication system DTCs output by the ECU can be displayed by using the Techstream.
  2. If CAN communication system DTCs are output, the trouble cannot be determined solely from the DTCs. Perform troubleshooting according to "How to Proceed with Troubleshooting" (Click here).

  1. MULTIPLEX TILT AND TELESCOPIC ECU

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    B2621
    Communication Interruption

  2. MAIN BODY ECU

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    U1002
    Lost Communication with Gateway Module
    U0199
    Lost Communication with "Door Control Module A"
    U0208
    Lost Communication with "Seat Control Module A"
    U1115
    Lost Communication with Tilt and Telescopic Module
    U0230
    Lost Communication with Rear Gate Module

  3. ECM

    HINT:
    1. DTC communication uses the CAN communication system.
    2. Distance control ECU data is also output.


    DTC No.
    Detection Item
    U0100 (*3)
    Lost Communication with ECM/PCM "A"
    U0101 (*1)
    Lost Communication With Transfer Case Control Module
    U0122 (*3)
    Lost Communication with Vehicle Dynamics Control Module
    U0123 (*2)
    Lost Communication with Yaw Rate Sensor Module
    U0126 (*3)
    Lost Communication with Steering Angle Sensor Module
    U0235 (*2)
    Lost Communication with Cruise Control Front Distance Range Sensor
    U1101 (*3)
    Lost Communication with Distance Control ECU
    U1102 (*2)
    Lost Communication with Radar Sensor
    1. *1: For vehicle with 2UZ-FE only. The ECM is malfunctioning if U0101 is output. Replace the ECM.
    2. *2: If U0123, U0235 or U1102 is output alone, the CAN bus is normal (Click herefor U0123, Click here for U0235 and U1102).
    3. *3: Dynamic laser cruise DTC.

  4. SKID CONTROL ECU

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    U0073
    Control Module Communication Bus OFF
    U0100
    Lost Communication with ECM/PCM "A"
    U0114
    Lost Communication with 4-Wheel Drive Clutch Control Module
    U0123
    Lost Communication with Yaw Rate Sensor Module
    U0124
    Deceleration Sensor Communication Circuit Malfunction
    U0126
    Lost Communication with Steering Angle Sensor Module

  5. COMBINATION METER ECU

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    U0100
    Lost Communication with ECM/PCM "A"
    U0129
    Lost Communication with Brake System Control Module

  6. AIR CONDITIONING AMPLIFIER

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    B1499
    Multiplex Communication Circuit

  7. SUSPENSION CONTROL ECU
    For Vehicle with air suspension system only.

    HINT:
    DTC communication uses the CAN communication system.

    DTC No.
    Detection Item
    U0100
    Lost Communication with ECM/PCM "A"
    U0122
    Lost Communication with Vehicle Dynamics Control Module
    U0126
    Lost Communication with Steering Angle Sensor Module

  8. STEERING ANGLE SENSOR

    HINT:
    The steering angle sensor is connected to the CAN communication system but CAN communication DTCs are not output.

  9. CENTER AIRBAG SENSOR

    HINT:
    The center airbag sensor is connected to the CAN communication system but CAN communication DTCs are not output.

  10. POWER STEERING ECU

    HINT:
    The power steering ECU is connected to the CAN communication system but CAN communication DTCs are not output.

  11. POWER BACK DOOR ECU
    For vehicle with power back door system only.

    HINT:
    The power back door ECU is connected to the CAN communication system but CAN communication DTCs are not output.

  12. 4WD CONTROL ECU
    For vehicle with 4 wheel drive only.

    HINT:
    The 4WD control ECU is connected to the CAN communication system but CAN communication DTCs are not output.

  13. DISTANCE CONTROL ECU
    For Vehicle with dynamic laser cruise control system only.

    HINT:
    The distance control ECU is connected to the CAN communication system but CAN communication DTCs are not output.

  14. BUS BUFFER ECU
    For vehicle with bus buffer ECU only.

    HINT:
    The bus buffer ECU is connected to the CAN communication system but CAN communication DTCs are not output.

  15. POWER SEAT CONTROL ECU
    For vehicle with front power seat control system (w/ Seat memory) only.

    HINT:
    The power seat control ECU is connected to the CAN communication system but CAN communication DTCs are not output.

  16. OUTER MIRROR CONTROL ECU
    For vehicle with front power seat control system (w/ Seat memory) only.

    HINT:
    The outer mirror control ECU is connected to the CAN communication system but CAN communication DTCs are not output.


DTC COMBINATION TABLE

V Bus 
Output from
Output DTC
Detection Item
Trouble Mode
Main Body ECU Communication Stop Mode
ECM Communication Stop Mode
Skid Control ECU Communication Stop Mode
Steering Angle Sensor Communication Stop Mode
Combination Meter ECU Communication Stop Mode
Center Airbag Sensor Communication Stop Mode
Skid Control ECU
U0073
Control Module Communication Bus OFF
□
□
□
□
□
□
U0100
Lost Communication with ECM/PCM "A"
-
-
○
-
-
-
U0114
Lost Communication with 4-Wheel Drive Clutch Control Module
-
-
○
-
-
-
U0123
Lost Communication with Yaw Rate Sensor Module
-
-
-
-
-
-
U0124
Deceleration Sensor Communication Circuit Malfunction
-
-
-
-
-
-
U0126
Lost Communication with Steering Angle Sensor Module
-
-
○
○
-
-
Combination Meter ECU
U0100
Lost Communication with ECM/PCM "A"
-
○
-
-
○
-
U0129
Lost Communication with Brake System Control Module
-
-
○
-
○
-
Air Conditioning Amplifier
B1499*1
Multiplex Communication Circuit
-
○
-
-
-
-
Suspension Control ECU
U0100*1
Lost Communication with ECM/PCM "A"
-
○
-
-
-
-
U0122*1
Lost Communication with Vehicle Dynamics Control Module
-
-
○
-
-
-
U0126*1
Lost Communication with Steering Angle Sensor Module
-
-
-
○
-
-
ECM
U0100*2
Lost Communication with ECM/PCM "A"
-
○
-
-
-
-
U1101*2
Lost Communication with Distance Control ECU
-
○
-
-
-
-
U0122*2
Lost Communication with Vehicle Dynamic Control Module
-
○
○
-
-
-
U0123*2
Lost Communication with Yaw Rate Sensor Module
-
○
-
-
-
-
U0126*2
Lost Communication with Steering Angle Sensor Module
-
○
-
○
-
-

HINT:
  1. ○: DTC is stored.
  2. □: Communication error status is stored. (e.g., 1 wire disconnection)
  3. *1: Only during failure status.
  4. *2: Only during ignition switch ACC.


V Bus 
Output from
Output DTC
Detection Item
Trouble Mode
Air Conditioning Amplifier Communication Stop Mode
4WD Control ECU Communication Stop Mode
Suspension Control ECU Communication Stop Mode
Power Steering ECU Communication Stop Mode
Distance Control ECU Communication Stop Mode
Skid Control ECU
U0073
Control Module Communication Bus OFF
□
□
□
□
□
U0100
Lost Communication with ECM/PCM "A"
-
-
-
-
-
U0114
Lost Communication with 4-Wheel Drive Clutch Control Module
-
○
-
-
-
U0123
Lost Communication with Yaw Rate Sensor Module
-
-
-
-
-
U0124
Deceleration Sensor Communication Circuit Malfunction
-
-
-
-
-
U0126
Lost Communication with Steering Angle Sensor Module
-
-
-
-
-
Combination Meter ECU
U0100
Lost Communication with ECM/PCM "A"
-
-
-
-
-
U0129
Lost Communication with Brake System Control Module
-
-
-
-
-
Air Conditioning Amplifier
B1499*1
Multiplex Communication Circuit
○
-
-
-
-
Suspension Control ECU
U0100*1
Lost Communication with ECM/PCM "A"
-
-
▲
-
-
U0122*1
Lost Communication with Vehicle Dynamics Control Module
-
-
▲
-
-
U0126*1
Lost Communication with Steering Angle Sensor Module
-
-
-
-
-
ECM
U0100*2
Lost Communication with ECM/PCM "A"
-
-
-
-
-
U1101*2
Lost Communication with Distance Control ECU
-
-
-
-
○
U0122*2
Lost Communication with Vehicle Dynamic Control Module
-
-
-
-
-
U0123*2
Lost Communication with Yaw Rate Sensor Module
-
-
-
-
○
U0126*2
Lost Communication with Steering Angle Sensor Module
-
-
-
-
○

HINT:
  1. ○: DTC is stored.
  2. □: Communication error status is stored. (e.g., 1 wire disconnection)
  3. ▲: DTC is not stored, but is output.
  4. *1: Only during failure status.
  5. *2: Only during ignition switch ACC.


MS Bus 
Output from
Output DTC
Detection Item
Trouble Mode
Power Seat Control ECU Communication Stop Mode
Outer Mirror Control ECU Communication Stop Mode
Multiplex Tilt and Telescopic ECU Communication Stop Mode
Power Back Door ECU Communication Stop Mode
Main Body ECU Communication Stop Mode
Multiplex Tilt and Telescopic ECU
B2621
Communication Interruption
○
-
○
○
○
Main Body ECU
U1002
Lost Communication with Gateway Module
-
-
-
-
○
U0208
Lost Communication with "Seat Control Module A"
○
-
-
-
○
U0199
Lost Communication with "Door Control Module A"
-
○
-
-
○
U1115
Lost Communication with Tilt and Telescopic Module
-
-
○
-
○
U0230
Lost Communication with Rear Gate Module
-
-
-
○
○

HINT:
○: DTC is stored.