Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Bluetooth Handsfree Module Communication Error

for Preparation Click here


INSPECTION PROCEDURE

1.IDENTIFY COMPONENT SHOWN BY SUB-CODE


  1. Enter the diagnostic mode.


    E146479E01

  1. Press the preset switch "3" to change to "Detailed Information Mode".

  1. Identify the component shown by the sub-code.

HINT:
  1. "190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
  1. For details of the DTC display, refer to "DTC Check/Clear" (Click here).


NEXT


2.CHECK COMPONENT SHOWN BY SUB-CODE
  1. Select the component shown by sub-code.

    HINT:
    The "Bluetooth" handsfree module is built into the radio receiver assembly. If there is a problem between the "Bluetooth" handsfree module and radio receiver assembly, replace the radio receiver assembly.

    Component Table 
    Component
    Proceed to
    Except Radio Receiver
    A
    Radio Receiver (190)
    B



B
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
A


3.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE
  1. Inspect the power source circuit of the component shown by the sub-code.
    If the power source circuit is operating normally, proceed to the next step.
    Component Table 
    Component
    Proceed to
    Stereo component amplifier (440)
    Stereo Component Amplifier Power Source Circuit (Click here)
    Television display (1B0)*
    Television Display Assembly Power Source Circuit (Click here)

    HINT:
    *: w/ Rear Seat Entertainment System


NEXT


4.INSPECT RADIO RECEIVER ASSEMBLY


    E145834E04
  1. Disconnect the I4 and I8* radio receiver assembly connectors.

    HINT:
    *: w/ Rear Seat Entertainment System

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I4-5 (ATX+) - I4-15 (ATX-)
    Always
    60 to 80 Ω
    I8-9 (TXM+) - I8-10 (TXM-)*
    Always
    60 to 80 Ω

    HINT:
    *: w/ Rear Seat Entertainment System

  1. Reconnect the radio receiver assembly connectors.



NG
REPLACE RADIO RECEIVER ASSEMBLY (Click here)
OK


5.CHECK HARNESS AND CONNECTOR ("BLUETOOTH" HANDSFREE MODULE - COMPONENT SHOWN BY SUB-CODE)

E142358E04

HINT:
  1. Start the check from the circuit that is near the component shown by the sub-code first.
  1. For details of the connectors, refer to "Terminals of ECU" (Click here).

  1. Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.

    1. Disconnect all connectors between the "Bluetooth" handsfree module and the component shown by the sub-code.

    2. Check for an open or short in the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.

      OK:
      There is no open or short circuit.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6.REPLACE COMPONENT SHOWN BY SUB-CODE
  1. Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.

    OK:
    Same problem does not occur.



NG
REPLACE RADIO RECEIVER ASSEMBLY (BUILT-IN "BLUETOOTH" HANDSFREE MODULE) (Click here)
OK

END