Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR

STEERING GEAR > REMOVAL

for Preparation Click here



1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE FRONT WHEELS


3. REMOVE ENGINE ASSEMBLY
  1. Remove the engine assembly.

    HINT:
    1. for 3UR-FE (Click here)
    2. for 2UZ-FE (Click here)
    3. for 3UR-FEB (Click here)



4. SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY


C155151E01
  1. Put matchmarks on the No. 2 steering intermediate shaft and the power steering gear.

  1. Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.



5. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    C179622E01
  1. Using SST, disconnect the tie rod end LH from the steering knuckle.

    SST
    09610-20012  

    NOTICE:
    1. Hang SST with a string, etc. to prevent it from falling.
    2. Do not damage the front disc brake dust cover.
    3. Do not damage the ball joint dust cover.
    4. Do not damage the steering knuckle.



6. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures for both sides.



7. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


    C181253
  1. Using a union nut wrench, disconnect the pressure feed tube (return tube side) from the power steering gear.



    C181254
  1. Using a union nut wrench, disconnect the pressure feed tube (pressure feed tube side) from the power steering gear.



    C181255
  1. Remove the 2 bolts and disconnect the pressure feed tube clamp.



8. REMOVE POWER STEERING GEAR ASSEMBLY


C181251
  1. Remove the 2 bolts, 2 nuts and power steering gear.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut fixed.