Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Rear Air Conditioning Control Panel Circuit

for Preparation Click here


DESCRIPTION

This circuit consists of the air conditioning control and the air conditioning amplifier. When the air conditioning control is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control is operated.

WIRING DIAGRAM


E157369E12


INSPECTION PROCEDURE

1.INSPECT FUSE (LH-IG)


    E160643E08
  1. Remove the LH-IG fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    LH-IG fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - FUSE, BODY GROUND)
  1. Disconnect the S4 air conditioning control connector.



    E161572E01
  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S4-4 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    S4-1 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Reconnect the air conditioning control connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)


    E161573E01
  1. Disconnect the S4 air conditioning control connector.

  1. Disconnect the H67 air conditioning amplifier connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H67-13 (RLIN) - S4-5 (RLIN)
    Always
    Below 1 Ω
    S4-5 (RLIN) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the air conditioning amplifier connector.

  1. Reconnect the air conditioning control connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE AIR CONDITIONING CONTROL
  1. Replace the air conditioning control with a new or properly functioning one (Click here ).

  1. Operate the rear power seat module to check that it functions properly.

    OK:
    Rear air conditioning control panel function operates normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END