Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > Air Conditioning Control Panel does not Operate

for Preparation Click here


DESCRIPTION

This circuit consists of the integration control and panel and the air conditioning amplifier. When the integration control and panel is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the integration control and panel is operated.

WIRING DIAGRAM


E157369E10


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG NO. 1)


    E160643E04
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPAIR FUSE
OK


2.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY, BODY GROUND)


    E161567E01
  1. Disconnect the H45 integration control and panel connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H45-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H45-1 (GND) - H45-16 (IG+)
    Ignition switch ON
    11 to 14 V

  1. Reconnect the integration control and panel connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - INTEGRATION CONTROL AND PANEL)


    E161568E01
  1. Disconnect the H45 integration control and panel connector.

  1. Disconnect the H24 air conditioning amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H45-3 (STX) - H24-37 (LIN1)
    Always
    Below 1 Ω
    H45-3 (STX) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the air conditioning amplifier connector.

  1. Reconnect the integration control and panel connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE INTEGRATION CONTROL AND PANEL
  1. Replace the integration control and panel with a new or properly functioning one (Click here).

  1. Operate the air conditioning control to check that it functions properly.

    OK:
    Air conditioning control function operates normally.



NG
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
OK

END (INTEGRATION CONTROL AND PANEL IS FAULTY)