Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 3UR-FE)


A184925
  1. Remove the bolt, clamp and gasket.

  1. Disconnect the tailpipe assembly from the exhaust pipe support.



3. REMOVE TAIL EXHAUST PIPE ASSEMBLY (for 2UZ-FE)


    A166393
  1. Remove the bolt and clamp.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.



4. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD)
(Click here)


5. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD)


    C158450
  1. Remove the 2 bolts and propeller shaft heat insulator.



6. REMOVE TRANSFER HEAT INSULATOR (for 4WD)


    C158451
  1. Remove the 3 bolts and transfer heat insulator.



7. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD)


    C179258E01
  1. Place matchmarks on the propeller shaft flange and differential flange.

  1. Place matchmarks on the propeller shaft flange and transfer flange.

  1. Remove the 8 nuts and then remove the propeller shaft assembly.



8. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


C180588
  1. Put matchmarks on the rear height control sensor link and bracket.

  1. Remove the nut and disconnect the rear height control sensor link.



    C180589
  1. Disconnect the rear height control sensor connector.

  1. Remove the nut and the rear height control sensor.



9. REMOVE REAR STABILIZER BAR
(Click here)


10. REMOVE REAR SHOCK ABSORBER ASSEMBLY LH


C180604
  1. Disconnect the AVS connector (w/ AVS).



    C180767
  1. Remove the 2 bolts and nut and remove the rear shock absorber.