Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for SD)

NAVIGATION SYSTEM (for SD) > GPS Mark is not Displayed

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CABIN
  1. Check the cabin for any object that might interrupt radio reception on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

    HINT:
    The GPS uses extremely weak radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.

    OK:
    Mark appears.



NG
Go to step 2
OK

NORMAL OPERATION 

2.CHECK SURROUNDINGS


  1. Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

    HINT:
    The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint the vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction and time. For examples, see the illustration below.


    I100196E36


    Text in Illustration 
    *a
    Example
    *b
    In a tunnel
    *c
    In a building
    *d
    Under an overpass
    *e
    On a forest or tree-lined path
    *f
    Between tall buildings
    *g
    Under a cliff or overhang
    -
    -

    OK:
    GPS mark is displayed.



NG
Go to step 3
OK

SYSTEM RETURN TO NORMAL 

3.CHECK GPS INFORMATION (OPERATION CHECK)


    E225802
  1. Enter the "GPS Information" screen (Click here).

  1. Check how many of the following codes appear in the "STS" column.

    HINT:
    T, U or P appears.

    OK:
    At least 3 codes appear.



NG
REPLACE NAVIGATION ANTENNA ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)