Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system.
    Use this procedure to troubleshoot the wireless door lock control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally.
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here).
    A


    4.DTC CHECK*
    1. Check for a DTC and note any codes that are output.

    2. Clear the DTC.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original symptom that the DTC suggests.
      Result 
      Result
      Proceed to
      DTC does not recur
      A
      DTC recurs
      B



    B.
    GO TO DTC CHART (Click here)
    A


    5.SYMPTOM SIMULATION

      NEXT


      6.PROBLEM SYMPTOMS TABLE
        Result 
        Result
        Proceed to
        Fault is not listed in problem symptoms table
        A
        Fault is listed in problem symptoms table
        B


      B.
      Go to step 9
      A


      7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM*
      1. Terminals of ECU (Click here)

      2. Data List/Active Test (Click here)


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END