Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use a Techstream to check if the CAN communication system is functioning normally (Click here).
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    4.SYMPTOM SIMULATION

      NEXT


      5.PROBLEM SYMPTOMS TABLE
        Result 
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Tablet
        B


      B.
      Go to step 7
      A


      6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. System Description (Click here)

      2. Terminals of ECU (Click here)



      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END