Home › Power Source / Network ยท NETWORKING › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


CAN Communication System 
DTC Code
Detection Item
DTC Output from
See page
B2621
Communication Interruption
Multiplex tilt and telescopic ECU
Click here
B2624
Vehicles Speed Malfunction
Multiplex tilt and telescopic ECU
Click here
U0104
Lost Communication with Driving Support ECU
Network gateway ECU
Click here
U0199
Lost Communication with "Door Control Module A"
Main body ECU (cowl side junction block LH)
Click here
U0208
Lost Communication with "Seat Control Module A"
Main body ECU (cowl side junction block LH)
Click here
U0230
Lost Communication with Rear Gate Module
Main body ECU (cowl side junction block LH)
Click here
U0232
Lost Communication with Blind Spot Monitor Slave Module
- Network gateway ECU
- Blind spot monitor sensor LH
Click here
U0233
Lost Communication with Blind Spot Monitor Master Module
- Network gateway ECU
- Blind spot monitor sensor RH
Click here
U1002
Lost Communication with Gateway Module
Main body ECU (cowl side junction block LH)
Click here
U1002 (CAN No. 2 BUS)
Lost Communication with Gateway Module (Network Gateway ECU)
Network gateway ECU
Click here
U1115
Lost Communication with Tilt and Telescopic Module
Main body ECU (cowl side junction block LH)
Click here