Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER (w/ Air Cooled Transmission Oil Cooler)

CONDENSER (w/ Air Cooled Transmission Oil Cooler) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.



    I104349E01
  1. Remove the caps from the service valves on the refrigerant line.

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE FRONT BUMPER COVER
  1. Remove front bumper cover (Click here).



3. DISCONNECT OIL COOLER HOSE


    E188044
  1. Using pliers, grip the claws of the clip and slide the clip.

  1. Disconnect the 2 oil cooler hoses.



4. REMOVE RADIATOR ASSEMBLY
  1. for 1UR-FE:
    Remove the radiator (Click here).

  1. for 3UR-FE:
    Remove the radiator (Click here).

  1. for 3UR-FBE:
    Remove the radiator (Click here).



5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


E207128
  1. Remove the bolt and disconnect the discharge hose from the cooler condenser.

    NOTICE:
    1. When removing the bolt, do not allow any tools to contact the pipe.
    2. When removing the bolt, hold a part of the pipe near the connector.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. DISCONNECT AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY


E186078
  1. Remove the 2 bolts and air conditioning tube and accessory from the cooler condenser.

    NOTICE:
    1. When removing the bolt, do not allow any tools to contact the pipe.
    2. When removing the bolt, hold a part of the pipe near the connector.

  1. Remove the O-ring from the air conditioning tube and accessory.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



7. REMOVE COOLER CONDENSER ASSEMBLY
  1. Remove the 2 bolts.



    E207129
  1. Remove the cooler condenser, as shown in the illustration.



8. REMOVE COOLER DRYER


    I030086E01
  1. Using a 14 mm socket hexagon wrench, remove the cap from the modulator.



    I032475E01
  1. Remove the O-ring from the cap.



    E050386E01
  1. Using pliers, remove the cooler dryer.