Home › Engine / Hybrid System ยท 1UR-FE › STARTING › STARTER (for 1.6 kW Type)

STARTER (for 1.6 kW Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
  1. Remove the exhaust manifold RH (Click here).



4. REMOVE STARTER COVER


    A215551
  1. Remove the 3 bolts and starter cover.



5. REMOVE STARTER ASSEMBLY


    A215550
  1. Disconnect the 2 wire harness clamps.

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A215548
  1. Remove the 2 bolts and starter.



    A215546
  1. Remove the flywheel housing side cover.