Home › Engine / Hybrid System ยท 1UR-FE › INTAKE / EXHAUST › EXHAUST MANIFOLD

EXHAUST MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 6 clips and fender apron seal.



2. REMOVE FRONT FENDER APRON SEAL REAR RH
  1. Remove the 5 clips and fender apron seal.



3. REMOVE FRONT FENDER APRON SEAL LH
  1. Remove the 6 clips and fender apron seal.



4. REMOVE FRONT FENDER APRON SEAL REAR LH
  1. Remove the 5 clips and fender apron seal.



5. REMOVE INTAKE MANIFOLD ASSEMBLY
  1. Remove the intake manifold (Click here).



6. REMOVE GENERATOR ASSEMBLY
  1. Remove the generator (Click here).



7. DISCONNECT COOLER COMPRESSOR ASSEMBLY


    I104396
  1. Disconnect the connector.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the 2 stud bolts and cooler compressor.



8. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
  1. Remove the dipstick.



    A216301
  1. Remove the bolt and dipstick guide.

  1. Remove the O-ring from dipstick guide.



9. REMOVE EXHAUST PIPE ASSEMBLY
  1. Remove the exhaust pipe (Click here).



10. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)


    C179230E02
  1. Place matchmarks on the differential and propeller shaft flange.

  1. Place matchmarks on the transfer and propeller shaft flanges.

  1. Remove the 8 nuts and 8 washers and remove the front propeller shaft assembly.



11. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR


    A184951
  1. Remove the 4 nuts and front floor heat insulator.



12. REMOVE FRONT NO. 3 FLOOR HEAT INSULATOR


    A184950
  1. Remove the 4 nuts and front floor heat insulator.



13. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY


    A214293
  1. Remove the 4 nuts and EGR pipe.

  1. Remove the 2 gaskets.



14. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A215348
  1. Remove the 3 bolts and heat insulator.



15. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    A215349
  1. Remove the 9 nuts, exhaust manifold and 2 gaskets.



16. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    A215350
  1. Remove the 3 bolts and heat insulator.



17. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    A215351
  1. Remove the 9 nuts, exhaust manifold and 2 gaskets.